Quote:
Originally Posted by Dieago62
I can tell you this I have 17000 on my bike 11000 when I bought it.
the pin bolt on swing arm was worn very bad where needle bearings run. the top bushing in fork tube was badly worn and steering bearings were not worn out but loose. All changed and drives like new again other than the Michelin C2 rear tire slips and drives funny until hot with only 6000 miles on it. it is cupped where the two outer tread groves meet. upon changing swing arm bearings and pin/bolt I drilled tapped and installed grease zurk so no I can grease it with grease gun
|
Gotta love it when a plan comes together. I think I sense a winter project coming on. Nice touch with the addition of the handy dandy grease piece install ...(going bez-zurk
). Cheers