|
|
08-07-2017, 09:27 AM
|
#16 |
|
Member
Join Date: May 2017
Location: Hazelhurst, WI
Posts: 101
|
When I was reading about the bearings for the harley wheels and I read the someone got an expanding concrete anchor that is big enough to fill the hole of the bearing. Tighten it down and then pound it out from the other side? I believe Fastenal has the anchors that are needed. Not sure if that is similar the the bearing pullers that have been linked above or not.
__________________
2008 Kawasaki Vulcan Nomad 1600 Batwing Fairing Russell Day Long Seat w/ drivers back rest Rest is stock (Currently) 
Login or Register to Remove Ads |
|
|
08-07-2017, 10:49 AM
|
#17 |
|
Member
Join Date: Nov 2014
Location: Auburn Al
Posts: 247
|
Yeah I looked into the wedge bolts. If this puller I ordered doesn't work ill look into that and call or order one in the 25mm range. I saw the vids on using that and it seemed to work so its another option.
__________________
2019 1700 Voyager VBA #02943 |
|
|
Linear Mode
