|
05-28-2011, 08:19 PM | #1 |
Member
Join Date: Mar 2011
Location: Evansburg, Alberta Canada
Posts: 293
|
Oil Site Glass/Oil Color/Possible Problem ?
Gentlemen, I appreciate your knowledge and expertise on this concern. I have a 2007 Kawasaki Vulcan Nomad 1600.
A few days ago I checked the antifreeze level and it was low (Previous owner advised me that in 18,000 kms., he had not added antifreeze or brake fluid-I just bought the bike this spring) I added a small amount of antifreeze to the reservoir-from the low mark to the full mark and after checking today on my return from a 65Km. ride I checked the antifreeze fluid level and it was down very slightly but right on the top level mark. Color is good and does not appear to have anything in it but antifreeze. I checked the oil level and could not see a distinct level mark as previously it was right in the middle of the site glass (Bike is upright and level). I waited a couple of hours and the site glass looked full but was hard to tell if it was full or empty (No oil leaks to be found anywhere) and appeared to be a bit of an off color rather than normal oil color. I started the bike and watched the site glass, the oil went down to where a line could be seen at the bottom of the site glass. I turned the bike off and the oil rose in the site glass to the top and there is no line between the 2 site marks. Oil fills the site glass. There is no space at the top of the site glass at all. -An oil change is a must but the previous owner advised he had just completed a change. Does anyone know what might be happening -or suggestions and if this should be checked by the dealer for other problems? Appreciate your advice on what might be happening and what action to take. Thanks! Dennis
__________________
FREEDOM ISN'T FREE *2007 Nomad Black & Titanium - Dennis -Evansburg, Alberta Canada KawaNOW #01721 Login or Register to Remove Ads |
|
05-28-2011, 08:58 PM | #2 |
Advanced Member
Join Date: Aug 2010
Location: Alexandria La.
Posts: 636
|
Oil Site Glass/Oil Color/Possible Problem ?
Sounds like it has to much oil if I'm reading your post correctly.I over filled mine once and drained a bit from the oil screen plug until the level was just below the full mark.Also i used a small bubble level on the swing arm to make sure the bike is truly level.
__________________
|
|
05-28-2011, 09:03 PM | #3 |
Member
Join Date: Mar 2011
Location: Evansburg, Alberta Canada
Posts: 293
|
Oil Site Glass/Oil Color/Possible Problem ?
Thanks will give it a try, I am just a little concerned about the color of the oil in the site glass. It was right in the middle of the site glass until today. Den
__________________
FREEDOM ISN'T FREE *2007 Nomad Black & Titanium - Dennis -Evansburg, Alberta Canada KawaNOW #01721 |
|
05-28-2011, 09:22 PM | #4 |
Advanced Member
Join Date: Aug 2010
Location: Alexandria La.
Posts: 636
|
Oil Site Glass/Oil Color/Possible Problem ?
Don't know about the color Den but I would drain some out and then you can see the oil better.If it is milky or cloudy you may have water in the oil.At any rate an oil change may be a good idea.
__________________
|
|
05-28-2011, 11:05 PM | #5 |
Join Date: Jan 2009
Location: Psychiatric Ward FL
Posts: 3,429
|
Oil Site Glass/Oil Color/Possible Problem ?
Pull the filter off and pour some oil into your drain pan. If the oil is good then put the filter back on and check the level. If you think it is high, just empty the filter before reinstalling then top off the level. Don't forget to run it before checking. That way you fill the filter with oil.
It kind of sounds like your filter is draining back into the sump. MT
__________________
MT 2016 FLHP Psychiatric Ward FL VBA 936 Login or Register to Remove Ads |
|
05-28-2011, 11:35 PM | #6 |
Member
Join Date: Mar 2011
Location: Evansburg, Alberta Canada
Posts: 293
|
Oil Site Glass/Oil Color/Possible Problem ?
Thanks MT!!! Do you think there might be antifreeze in the oil ?Den
__________________
FREEDOM ISN'T FREE *2007 Nomad Black & Titanium - Dennis -Evansburg, Alberta Canada KawaNOW #01721 |
|
05-28-2011, 11:58 PM | #7 |
Join Date: Jan 2009
Location: Psychiatric Ward FL
Posts: 3,429
|
Oil Site Glass/Oil Color/Possible Problem ?
You will have to look at some of the oil to determine that.
But most likely the reserve would be completely empty if you had a leak into the oiling system. I still think the filter is letting go of some of the oil. MT
__________________
MT 2016 FLHP Psychiatric Ward FL VBA 936 |
|
05-29-2011, 07:17 AM | #8 |
Member
Join Date: Aug 2010
Location: hermitage tenn
Posts: 410
|
Oil Site Glass/Oil Color/Possible Problem ?
If in dought I would go ahead and do a fresh oil and filter change anyway It can' hurt anything and then you will start from fresh and will have peace of mind,Add recommended amount of oil for you're bike!
|
|
05-29-2011, 09:58 AM | #9 |
Sr. Member
Join Date: Jan 2010
Location: Makawao, Hawaii
Posts: 1,409
|
Oil Site Glass/Oil Color/Possible Problem ?
A slight lean off center and the oil level will read very differently, sounds like you know that though. I found that just a 3 degree angle right will look over filled and 3 degrees left will look empty. I hate the oil sight glass on the Nomad, bad location and not accurate. I always check the oil when I clean the bike on my lift. I put a 3 foot level across the luggage rack and level out the bike the same every time. May not be completely accurate but repeatability is the main concern by checking it the same way every time.
You say the oil is a little off color, not sure what you mean but like others have said when in dought change the oil. |
|
05-29-2011, 10:24 AM | #10 |
Member
Join Date: Mar 2011
Location: Evansburg, Alberta Canada
Posts: 293
|
Oil Site Glass/Oil Color/Possible Problem ?
Thanks for the info guys, will let you know what happens, as you stated, the reservoir for the antifreeze should be empty if a problem there. Hope no leaks. Have a safe day. Dennis
__________________
FREEDOM ISN'T FREE *2007 Nomad Black & Titanium - Dennis -Evansburg, Alberta Canada KawaNOW #01721 |
|
05-29-2011, 11:09 AM | #11 |
Mega-Contributor
Join Date: Sep 2007
Location: Where it doesn't snow...ever!
Posts: 21,926
|
Oil Site Glass/Oil Color/Possible Problem ?
Get yourself a telescoping inspection mirror and carry it around in your saddlebag. Sit astride the bike, level it with your legs and use the mirror to read the oil level in the sight glass.
__________________
Scott "Cactusjack" Hanks VBA #00105 H.O.G. #4250060 2011 H-D Ultra Limited 103ci :: 2011 HD Electra Glide Ultra Limited w/Stage 1 :: Rallies: Mesquite '08|Custer '09|Cortez '10|Crescent City '11|Kanab '12|Antlers '12|Estes Park '13|Antlers '13|Orofino '14|The Dalles '17 |
|
05-30-2011, 09:38 PM | #12 |
Member
Join Date: Dec 2009
Location: Calgary, Alberta Canada
Posts: 340
|
Oil Site Glass/Oil Color/Possible Problem ?
Your anti-freeze and oil levels just need to be roughly midway be between the marks (bike level). There is no reason to bring it all the way up to EXACTLY the top mark. As long as fluids are between the marks you're good.
The off color could be the type of oil used (Rotella T6 diesel looks different then LUCAS Semi-synthetic). A quality filter with an anti-drainback valve, such as WIX 51358 or NAPA 1358 should also be used. Probably wouldn't hurt to change your final drive gear oil at the same time, I always do both together. Then you know your good.
__________________
'08 Blue/Silver |
|
05-31-2011, 03:51 AM | #13 |
Sr. Contributor
|
Oil Site Glass/Oil Color/Possible Problem ?
I'm with CactusJack get you a telescoping mirror and sit on the bike on level ground. Hold the mirror and check your oil that way. If it appears to have too much oil drain some of it out. Don't won't to blow any seals with too much oil in it. I would change the oil to be on the safe side and inspect the oil that comes out in a clean drain pan. Just my thought.
__________________
Gene Cross, Jr. Boaz, Alabama KawaNOW/VBA #1181 |
|
05-31-2011, 07:32 AM | #14 |
Join Date: Aug 2007
Location: Newmarket Ontario Canada
Posts: 35,387
|
Oil Site Glass/Oil Color/Possible Problem ?
I always use a measuring cup when I add the oil while doing a change. It takes 3.3 litres to fill with a new filter installed.
__________________
2002 Nomad aka Bountyhunter VBA #27 VROC #18951 |
|
05-31-2011, 09:40 AM | #15 | |
Advanced Member
Join Date: Dec 2009
Location: Cleveland Ohio
Posts: 714
|
Oil Site Glass/Oil Color/Possible Problem ?
Quote:
Your oil is overfilled or you had the lean off a little on the bike. At the same time your coolant cap under the tank or the hoses that connect to it are leaking just a little bit...it hits the engine and burns off and you never see the leak. Very common on this bike, probably the front hose. MaKaw did not tighten those hoses very well. Drain some oil and get that squared away and pull the tank and look for leaks. Pulling the tank is not as hard as it sounds if you have not done it. Very easy job. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
oil sending unit install problem | voyager | 1500 & 1600 Nomad | 2 | 09-02-2011 04:35 AM |
How to check the oil with the Sight Glass | eagle | Off-Topic | 11 | 02-25-2010 07:34 AM |
Will a different weight oil fix a seepage problem? | shawman | 1500 & 1600 Nomad | 5 | 09-30-2009 09:50 AM |
Oil and gear oil change | coacha | 1500 & 1600 Nomad | 21 | 07-20-2008 09:36 AM |
Moisture in oil sight glass | Vulcan Nomad/Vaquero/Voyager | 7 | 03-29-2008 09:30 AM |