|
02-08-2012, 02:31 PM | #1 |
Member
Join Date: Jan 2012
Location: Tyler, TX
Posts: 169
|
Ultimate Midrider seat install on Vaquero
ENJOY!
Install Kit Nylon washer spacers = 4 pcs. Top rear fender bracket = 1 pc. Button head 1/4” x 5/8" bolts = 2 pcs. Nyloc nuts 1/4” = 2 pcs. Washers 1/4” flat = 2 pcs. Allan key 4 mm = 1 pc. Remove stock seat 1. Remove the left (clutch) side saddle bag (10 mm socket) 2 bolts inside 2. Disconnect the cable from the latch and the cable fastener (10 mm wrench) 3. Remove the latch assembly from the rail (two Philip head screws) Store the plate that the cable was attached to, no longer needed. 4. Reposition the cable under the frame rail and then reconnect to the latch 5. Reinstall the latch assembly (Philip head screws) with the two nylon washers between the latch and rail, these replace the plate that you removed. 6. Install the two 1/4" x 5/8" bolts and washers under the fender, while holding the bolts in place in the two holes install the two nylon washers and upper rear fender bracket and secure with the two supplied nyloc nuts. 7. Install your new Ultimate rider seat by locating the front seat bracket under the tank locater and rear bracket onto the locater pins. 7. To install your new Ultimate passenger seat, locate the rear seat bracket into the rear fender bracket and push down on the front of the seat to lock into the key lock. Make sure it clicks into the lock. Ride on rain covers Slip on over seat
__________________
traded the vaquero on a streetglide Login or Register to Remove Ads |
|
02-08-2012, 04:59 PM | #2 |
Sr. Member
Join Date: Aug 2008
Location: wheatland,wy.
Posts: 3,642
|
enjoy the new seat
__________________
bob wittman VBA # 745 COG #11621 wheatland,wy. rallies-custer 09,kalispell 10,crescent city 11,kanab 12,estes park 13,orifino 14.,red lodge 16 2015 ninja 1000 abs 2014 concourse 14 2012 concourse 14-sold 2011 vaquero-sold 2008 nomad-sold 2005 classic-sold |
|
02-28-2012, 04:17 PM | #3 |
Member
Join Date: Jan 2012
Location: Tyler, TX
Posts: 169
|
__________________
traded the vaquero on a streetglide |
|
02-28-2012, 04:43 PM | #4 |
Join Date: May 2009
Location: Montreal QC
Posts: 12,034
|
So, What was it you disliked about the seat? from a purely visual aspect I think the stock seat looks nicer.
__________________
Norm Ward 2008 blue / silver nomad kawanow / VBA #01136 |
|
02-28-2012, 05:44 PM | #5 |
Member
Join Date: Jan 2012
Location: Tyler, TX
Posts: 169
|
Wasn't 600 dollars better than my stock seat... Ass didn't go numb but did have some discomfort... You could see the rear seat bracket
__________________
traded the vaquero on a streetglide Login or Register to Remove Ads |
|
02-28-2012, 09:18 PM | #6 |
Sr. Member
Join Date: Mar 2009
Location: Henderson, NV
Posts: 3,746
|
For $600 it should have powdered your ass every 10 miles.
__________________
Oldest Saloon In Nevada http://www.pioneersaloon.info/ "Sin City Stan" Henderson, NV VBA #01004 VROC #29365 2004 Nomad 1500L5 +100 "The Bike" 2009 Nomad 1700 (past) 2004 Vulcan Classic 800 (past) 2010 Cortez - 2011 Crescent City - 2012 Kanab - 2013 Estes Park |
|
02-28-2012, 09:22 PM | #7 |
Member
Join Date: Jan 2012
Location: Tyler, TX
Posts: 169
|
Yes sir! so you understand my issue...mildly better seat...or PCV with an air kit!
I think the rider and passenger seat, without back rest was $525.
__________________
traded the vaquero on a streetglide |
|